Forums
HP2 Enduro.com :: Forums :: Forums :: Technical
 
<< Previous thread | Next thread >>
Touratech quick fastener seat pin
Moderators: blackSP, space, greatx
Author Post
Mago
Sat Oct 27 2018, 01:57pm
Registered Member #248
Joined: Wed May 05 2010, 05:25am

Posts: 14
Hi,

Lost the dzus 1/4 turn touratech seat bolt.Need to locate or maybe fabricate a new one. Anyone has its dimensions?

Thanks.
Back to top
Tabasco
Sun Oct 28 2018, 12:57pm
Double Down
Registered Member #94
Joined: Sat Apr 04 2009, 02:12pm

Posts: 18
I would like to know this too.......
Back to top
marret
Mon Oct 29 2018, 03:17pm
Registered Member #875
Joined: Wed Dec 16 2015, 05:39pm

Posts: 35
I have the TT bolt. I think M6 is correct. Mine is 28mm long instead of 30mm.
Back to top
Mago
Mon Oct 29 2018, 03:38pm
Registered Member #248
Joined: Wed May 05 2010, 05:25am

Posts: 14
Great, thanks
Back to top
rokrie
Tue Oct 30 2018, 02:31am
Registered Member #687
Joined: Thu Aug 15 2013, 11:01pm

Posts: 88
FYI: Attached is the Touratech Spec Sheet and installation instructions. If anybody finds a replacement part(s), please post! I'd like to get another set for my other HP2.

Thanks....Bob
09-044-2130-1.pdf
Back to top
Mago
Tue Oct 30 2018, 06:36am
Registered Member #248
Joined: Wed May 05 2010, 05:25am

Posts: 14
Bob,

I've seen this spec sheet before, but does not show the pin length. I've ordered two screws, one 26mm, the other 35mm. Those are all I could find around. One of them should work, with a spacer. I will come back with my findings once done.
Back to top
Tabasco
Fri Nov 02 2018, 03:52am
Double Down
Registered Member #94
Joined: Sat Apr 04 2009, 02:12pm

Posts: 18
Watching also....thank you.
Back to top
Mago
Sun Nov 04 2018, 05:46pm
Registered Member #248
Joined: Wed May 05 2010, 05:25am

Posts: 14
A 24mm will do. A 26mm was too loose. Will install a 2mm washer/spacer.
Could be m6 or m8.

[ Edited Sun Nov 04 2018, 05:47pm ]
Back to top
 

Jump:     Back to top

Syndicate this thread: rss 0.92 Syndicate this thread: rss 2.0 Syndicate this thread: RDF
Powered by e107 Forum System
File_get_contents() error
TERMS AND CONDITIONS OF USE

Thank you for visiting hp2enduro.com. If you want to use this website, you must agree to conform to and be legally bound by the terms and conditions described below.
IF YOU DISAGREE WITH ANY OF THESE TERMS OR CONDITIONS, DO NOT USE OUR WEBSITE.

The full conditions can be found here